The NEW Patented DUAL V RETURN TRACKER and DUAL FLAT RETURN TRACKER are the only Dual Roller design trackers that can be installed on either the dirty side or clean side of the belt. These trackers have a multi pivot design which uses a mechanical advantage to shift the guide roller and move the two steering roller with minimum force to its correct position. The two roller design is installed on flat return belts and V return belt. The DUAL V RETURN TRACKER is used on V return rollers configurations from 5 degree to 35 degree. The two roller design is typically used on belt widths of 60” to 168”. The load capacity is twice the FLAT RETURN TRACKER and will accommodate the higher tension and higher speed belts. Because the guide rollers are set approx. ¼ ` from the belt edge they can since smaller movements of the belt and make correction after very slight misalignment. Rather than waiting for a powerful mistracking force, the multi pivot design adjusts constantly reacting to small mistracking forces, providing continuous precise corrections of the steering roller.

With the installation on the inside (clean side) of the conveyor belt, the rubber lagged steering roller maintains proper tension and positive contact between the roller and the conveyor belt. No fugitive material will cause seizure or failure to the steering roller. The range of motion and seizure of the pivoting bearings is not effected do to the installation. Unlike most training rollers on the market, the Sure Align Tracker is one of the few who will guarantee the steering roller will always be in the proper position to steer the belt back to its centered position. The Sure Align Tracker is a patent proven training roller. With its unique design, this training roller will continually correct belt misalignment and provide a reliable conveyor belt system.